Unisys Aquanta CP Series, Руководство по настройке

Страница: 29 / 89

Upgrading Your System
3814 9779-000 1–17
Installing Feature Boards
To install a feature board, complete the following steps:
1. Turn the system off. Disconnect the power cord and all peripherals.
2. Remove the system unit cover, as described earlier in this section.
3. Remove the screw that secures the slot bracket to the chassis (shown in Figure 1–
7). Set the screw aside for later use.
4. Slide the slot cover out. Save it in case you ever need to remove the feature board.
5. Remove the feature board from its packaging.
6. Refer to the manufacturer’s instructions provided with your new board, and set
any necessary switches or jumpers on the board.
Caution
Touching the gold connector edge of the board can damage the board.
Always follow ESD precautions when handling a feature board.
7. Holding the board by its side and top edges, insert the tip of the board slot cover
into its holder, then insert the feature board connectors into the riser card slot.
8. Press the board into the slot until it is evenly and fully seated.
9. Secure the feature board to the chassis by clamping it with the slot bracket, then
securing the bracket to the chassis using the screw removed in step 3.
Caution
If you drop the screw into the system unit, be sure to retrieve it before
continuing. A loose screw can damage your equipment by causing a
short.