Unipro 03-05-001, Руководство пользователя

Страница: 19 / 56

19
Q u i c k G u i d e
Quick guide
Example on the help text describing the
current selection.
FIRST SETUP
When UniGo starts for the first time it will
show the setup screen shown below. This
contains essential setup of the most important
settings. It included settings like user interface
language, country you are driving in and what
type of units to use.
First setup. Essential settings needed to get
started with UniGo One.
Please set “AUTO TRACK SELECT” to Yes
and then select the country you are in.
To read more information about the first setup
settings, please look in the “Configuring the
Laptimer” chapter.
DRIVING
When UniGo detects a RPM signal from the
engine, it will automatically go to run mode.
It will automatically start to log all data from
sensors and measure lap and split times.
Typically run mode 1 when driving.
There is not much you can do in run mode ex-
cept concentrating on driving! You will be able
to change between three predefined layouts
by pressing the
mode button ( ). This will
toggle through the different run modes. UniGo
will remember the one you prefer and it will
start in the same mode as the last time.
• Run mode 1 is for four data fields.
• Run mode 2 is for gear karts with two
data fields and last lap data.
• Run mode 3 is for two data fields with
best lap information and last lap data.
ANALYZING
When analyzing you will typically start with the
overview screen. This screen will give you the
quick overview of the three best laps with the
minimum and maximum values for the most
important sensors.
Quick overview of three best laps in analyze
mode.
You can toggle around different analyze
screens by pressing the
mode button ( ).
Another important screen is the lap and split
times screen.