Unipower Sageon Shield 103-4023-01, Инструкция по установке и настройке

Страница: 7 / 38

Sageon Shield Standalone Battery Monitor
PM990-4023-01, Issue 4 1
1. INTRODUCTION
The Sageon Shield Standalone Battery Monitor is a complete solution for monitoring the status of a 48V battery
string. The Sageon Shield Battery Monitor will monitor individual cell voltage, ambient and pilot cell
temperature, and battery string charge/discharge current (optional). Using UNIPOWER’s Sageview software the
user can obtain a snapshot view of the present state of the batteries remotely via the integral Web/SNMP interface
card, or locally at the unit via the front panel USB connection. Alarming is provided via five user configurable
relays that can be triggered on a variety of battery conditions; by default, these relays will “trip” on high battery
cell voltage, low battery cell voltage, high cell voltage deviation, low cell voltage deviation, and high ambient or
battery temperature.
Figure 1. Sageon Shield Standalone Battery Monitor
2. INSTALLATION
2.1. MOUNTING THE POWER SHELF
The battery monitor is mounted into a standard 19” rack using 12-24 screws. A minimum of four screws are
required to secure the Power shelf into the rack. It is recommended to initially install the Power shelf into the rack
without the Controller in place. 23” mounting brackets are available; consult factory for part numbers.
Figure 2. Mount points for securing battery monitor in a rack
Wiring for the standard Power shelf is rear access only.
2.1.1. Tools Required for Installation
•
No. 2 Phillips-screwdriver (for tightening rack bolts)
•
No. 1 Phillips-screwdriver (for removing back panel screws)
•
3/32” Slotted-screwdriver (for tightening terminal block connections)