Unipower Sageon Shield 103-4023-01, Инструкция по установке и настройке

Страница: 8 / 38

Sageon Shield Standalone Battery Monitor
PM990-4023-01, Issue 4 2
2.1.2. Gaining Access to Wiring
WARNING: Access to the rear wiring should be limited to qualified service personnel. It is recommended to
remove the power before gaining access to the rear wiring due to the safety hazard present inside the electrical
enclosure. Similarly, the energy hazard associated with wiring connected to the batteries bus must be addressed
through the use of appropriately insulated tools and other measures to prevent accidental short circuits to the DC
bus.
Figure 3. Opening top rear cover to access wiring
All connections to the Sageon Shield Standalone Battery Monitor are made at the rear of the unit and within the
battery connection module. To open the top rear cover, remove the two rear M3 screws securing the cover to the
back. The top cover will then hinge up to provide access to the wiring. To gain access to the boards in the battery
connection module remove the (2) 4-40 screws from the front panel and slide the cover forward.
Figure 4. Sageon Battery monitor internal PCBs
Battery
Monitor Board
Battery
Distribution
Board