unipo UFP 6", Руководство по эксплуатации

Страница: 37 / 96

Universal unipo® Flat Panel UFP
Installation and start-up
Revision status 19.01.2010
35
5.3.2 AC - Version
The UFP can be connected to the 84 V
AC
– 264 V
AC
voltage supply by means of an inlet
connector for non-heating appliances. The UFP has no additional On/Off-switch.
WARNING! Danger caused by electric current!
Improper connection causes danger of electric shock.
The structure of the device is in accordance with degree of protection 1. Before
connecting the UFP to the voltage supply the protective earth must first be
connected through the DIN/IEC inlet connector for non-heating appliances. The
corresponding connecting cable must always have an earth conductor.
Any interruption of the earth conductor inside or outside the device is prohibited
for safety reasons!
5.3.3 DC - Version
The UFP must be connected to the 18 V
DC
- 32 V
DC
voltage supply by means of the
connecting plug. Correct polarity must be assured. The polarity of the input voltage is
identified.
WARNING! Danger caused by electric current!
Improper connection causes danger of electric shock.
The structure of the device is in accordance with degree of protection 1. Before
connecting the UFP to the voltage supply the protective earth must first be
connected. On the UFP this is accomplished via a screw connection on the
earthing bolt on the back of the metal housing.
Any interruption of the earth conductor inside or outside the device is prohibited
for safety reasons!