unipo UFP 6", Руководство по эксплуатации

Страница: 38 / 96

Universal unipo® Flat Panel UFP
Installation and start-up
36
Revision status 19.01.2010
5.4 Start-up
5.4.1 Measures before starting the UFP
Please observe before starting the device:
• Check all previously loosened screw connections for tight fit.
• Check all previously loosened plug/cable connections for tight fit.
• Check whether all previously removed covers are properly installed again.
• Make sure that all tools, materials and other equipment used were removed again from
the work area.
• Clean up the work area and remove any substances, such as fluids or similar, that may
have leaked out.
• Make sure that all safety features on device and system are restored to good working
order.
5.4.2 Starting the device
1. Switch on the machine.
2. The device will run an automatic setup process (duration approx. 10 sec.).
The screen shows the corresponding image.
3. If the image quality is sufficient, the installation process can be quit at at this point.
4. If the image quality is not sufficient, further manual adjustments can be made.
For information on manual adjustment of the UFP refer to the following chapters:
Chapter 6 Software description
Chapter 8 Faults