23
Setting Form to Impression Roller Pressure
1. Set the Coating Form Roller to the Impression Roller Pressure
NOTE:
Make sure the Coating Unit is completely clean with NO coating in the unit!
a.
Take a sheet of the stock that you plan to coat and cut (2) two 1” x 12” (25mm x 305mm) strips.
b. Slide the strips of the paper half way of its length, between the Form & Impression Roller, into
the machine at each side.
c. Adjust the Impression “Clicker Knobs” until there is a
LIGHT
, even drag on each of the strips.
d. Check that you can see a slight gap between the Form Roller and Impression Roller. If the roll-
ers are touching there is too much pressure!
NOTE:
Turning the Impression Clicker Knob Clockwise will decrease the pressure between the
Form Roller and Impression Roller and Counterclockwise will increase the pressure between the
Form Roller and Impression Roller. It is critical that the drag on both sides is even.
Impression Clicker Knob
Figure - Form to Impression Roller Pressure
