[ 5 7 ] T H E I N T E G R A T E D A N S W E R I N G D E V I C E
w w w . u n i d e n . c o m
Turning the Answering System On/Off
1) To turn the answering system on, press
answer on/
off
on the base when the phone is in standby mode.
and the number of messages stored in memory
appears on the LCD. If the LCD flashes, then there are
new messages waiting for you.
2) To turn the answering system off, press
answer on/
off
on the base.
appears on the LCD.
Setting Your Outgoing Message (Greeting)
When you receive a call, the answering system automatically plays either the pre-
recorded message or your own greeting. To record your own greeting, or choose
between the two outgoing messages, refer to “Answering System Setup” on
page 53.
The following message is pre-recorded: "Hello, no one is available to take your call.
Please leave a message after the tone."
Announce only feature
The announce only feature plays a pre-recorded outgoing message or your own personal
outgoing message, but it will not allow the caller to leave a message. To set announce
only, follow the steps on "Setting the Record Time" page 55. If you want to use your
own greeting and you want to change your greeting to omit the prompt to leave a
message, refer to “Selecting Your Greeting (Base only)” on page 53.
The following message is pre-recorded:
"Hello, no one is available to take your call. Please call again."
/'55#)'
1((
#059'4
•When the answering
system is full, you will
hear “No Remaining
Time“ and
appears
on the LCD. You should
delete some messages
so that the system can
record new messages.
•Position yourself as
near to the base as
possible and speak
clearly when recording
your outgoing
message.
•If you make an outside
call or a call is
received during the
operation, the
operation is canceled.
note
(7..
T
H
E I
N
TEG
RA
TE
D
ANSWERING DEVIC
E
UP779B.book Page 57 Wednesday, July 13, 2005 4:32 PM
