unicraft HZ 751, Руководство по эксплуатации

Страница: 9 / 20

Operation
HZ-Serie | Version 1.03 9
8 Operation
8.1 Operating conditions
The working area must be dry, fire and explosion pro-
tected and free of any corrosive or poisonous sub-
stances.
The lever hoist must not be used to lift or move danger-
ous goods such as molten, poisonous or radioactive
materials.
Operating temperature range: -10 °C to +50 °C
8.2 Test run
Before using the lever hoist to lift a load, a no-load test
should be carried out to test all functions.
8.3 Raising a load
Step 1: Attach the lever hoist to a suitable carrier with
the carrier hook and close the safety catch.
Step 2: Set the shift lever to the NEUTRAL position.
Step 3: Pull through the unloaded chain.
Step 4: Hook the hook of the lever hoist at a suitable at-
tachment point of the load and close the safety
lock.
DANGER!
Danger of life by crashing the load!
Falling loads can cause serious injury or death.
- Overload is prohibited! Check that the load never
exceeds the maximum load stated on the name-
plate.
- Loads may only be moved under supervision.
- Never swing the lifted load.
- Never step under suspended loads or work there.
- Under no circumstances may a load be subjected
to a heavy blow or collision.
- Make sure that the stop on which the lever hoist is
mounted has sufficient load capacity to hold the
load.
- Never lift a load that can fall off, or fall down, or
whose parts are not firmly connected to each other,
with the lever hoist.
- Never use a rusted or damaged lever hoist.
- Never leave a load lifted by the lever hoist unat-
tended.
- When lifting or lowering a load, make sure that the
operator is out of range of the load at all times.
- When leaving the workplace, lower the load.
DANGER!
Danger of life by crashing the load!
Unsuitable lifting points can fail and the load can
crash.
- Only attach to suitable points of the load.
Head protection must be worn!
Use protective gloves!
Use protective boots!
Wear protective clothes!
NOTE!
- Operating personnel must be familiar with the oper-
ation and functions of the lever hoist and the safety
regulations pertaining to it.
- The operator is responsible for ensuring that all op-
erating personnel have had the necessary training.
ATTENTION!
The operator must have a clear view over the entire
stroke. If this is not possible, a second person must
be available for instruction.
The operator must check that the entire lifting proce-
dure is safe before operating the hoist.
ATTENTION!
Do not overtighten the load chain with the mode-
selection switch in the middle position, as this will
activate the brake.
RESET: For releasing the brake, pull the load chain a
short distance in the opposite direction.