Unico MCV85 TOTAL CLEAN & TURBO, Инструкция по эксплуатации

Страница: 40 / 116

ENGLISH
| 40 |
27. TROUBLESHOOTING - TIPS
PROBLEM CAUSE SOLUTION
UNICO does not turn on. No power. Check the cable, plug and socket.
The motor revs/has little suction Tubes or accessories blocked Turn the appliance off, unplug, remove any
blockages in the tubes and accessories.
UNICO has no/reduced suction Dirt collector full or not correctly
inserted.
Suction adjustment set at the minimum
level.
Dirt collector or vacuum tube not
correctly inserted.
Clogged filters.
Clogged suction tubes.
Empty the dirt collector and insert correctly.
Adjust suction using the cursor on the handle.
Correctly insert the dirt collector tank and/or check
that the flexible vacuum tube has been correctly
inserted.
Proceed with filter cleaning as described in chapter 18.
Clean the tubes, as described in Chapter 22.
Water collects under the appliance during
vacuuming of liquids and/or damp dirt. Liquid in dirt collector has exceeded the
MAX level.
Foam in the dirt collector.
Empty the dirt collector.
Follow the cleaning instructions in Chapters 17 - 18
- 22.
UNICO does not dispense steam. Boiler switched off.
Boiler out of water.
Steam hose not inserted.
Steam lock activated.
The boiler is not yet pressurised.
Turn on the boiler button.
Add water to the tank as described in Chapter 15.
Connect the steam hose to the flexible vacuum
tube, locking the automatic buttons; connect the
steam hose to the appliance and the handle (as
described in Chapter 1 and shown on page 2).
Deactivate the steam lock on the handle.
Wait for the steam indicator light to stop flashing.
The universal brush selector does not work. The holder with cloth for steam cleaning
is mounted on the brush.
Remove the holder with cloth from the brush.
In preset-program mode, at the end of suction,
there was no time to finish drying. Vacuuming too slowly over the surfaces. In preset-program mode, it is still possible to
activate suction by pressing the suction button.
During cleaning operations, lines or traces of
dirt remain. The Multibrush is dirty. Clean the Multibrush by washing it under running
water and wait for it to dry completely before using
it again.
Non-uniform drying of the hard floor. The rubber inserts are worn. Replace the inserts, as described in Chapter 23.
UNICO MCV80-MCV85 - M0S11431 - 1Q09:UNICO 30/08/2016 16.17 Pagina 40