Unical XC-K Series, Инструкция по установке и обслуживанию

Страница: 56 / 60

56
Inspections and maintenance
Boiler body maintenance
Danger!
Before performing any maintenance, make
sure the boiler and its components have
cooled off.
Disconnect the boiler from the electric mains
and shut the gas supply to the appliance.
Attention!
Before cleaning the boiler body, protect the
panel board against any water sprays.
Once a year, at the end of the heating season, the boiler must
receive a general cleaning.
Before performing any maintenance, make sure that all the
precautions referred to in the previous point have been taken.
To proceed with maintenance you must:
- disconnect power by acting on the main switch;
- remove the burner, which could be overhauled at the
same time;
- open the furnace door to access the combustion
chamber;
- make sure the internal parts are intact.
Checking gasket status
Check the status of the seal gaskets which must
not show signs of deterioration; if so, they must
be replaced, using only original spare parts.
Maintenance of burner
Burner maintenance must be carried out by personnel authorised
by its manufacturer (or else the warranty shall be terminated).
Checking ignition electrode
Burner maintenance must be carried out by personnel authorised
by its manufacturer (or else the warranty shall be terminated).
COMPONENT:
Safety thermostat
System expansion vessel
Door gaskets
Smoke chamber gaskets
VERIFY:
Does the thermostat place the boiler in
safety when overheating?
Does the vessel contain the right amount
of air?
Does smoke seep through the door
gaskets?
Does smoke seep through the smoke
chamber gaskets?
CONTROL/INTERVENTION MEASURE:
Bring the boiler to operating temperature
with the pumps stopped.
Check the nitrogen pressure.
Pressurise the boiler (open the pump
bleeder). Open the heating circuit closing
valves.
Further tighten the door nuts.
Replace the sealing gasket.
Further tighten the smoke chamber nuts.
Replace the sealing gaskets.
Components to check during yearly inspection