USER MANUAL - URS600CE AND URS600CESS JULY 2019
22
The URS600CE is ready for the next operation. At this moment, the Ready L, Ready M and/or the Ready H
LED lights are lit in accordance with the temperature setting, but the FAN and HEAT LED lights are not lit.
The recycling process is complete.
3.7. Handling the waste and recycled solvent.
1. Remove the receiving container with recycled solvent and seal it with the original supplied cap.
2. Do not store the recycled solvent in the URS600CE.
3. Remove the retainer ring holding the liner bag in place.
4. Carefully remove the liner bag with the remaining waste from the distillation tank. Ensure the bag does
not tear or get damaged.
Please note!
It is possible that the residue of some paints remains moist after recycling due to the
composition of the paint. It is not guaranteed that the residue will be dry.
5. Dispose of the waste according to regional regulations.
The URS600CE is now ready to be cleaned.
3.8. Cleaning the tank and lid
1. Remove any residual waste material from the tank. Use plastic or wooden tools as necessary.
Please note!
Do not use abrasive or hard metal tools that could damage the tank. This damage is not
covered by the warranty.
2. Wipe the tank clean and dry with a dry cloth.
3. Clean the lid and the top of the tank where the lid sits and dry with a dry cloth. This prolongs the life of
the lid gasket and prevents leakages. Avoid turning the lid during cleaning.
Please note!
A small amount of solvent may remain in the tank after the recycling process due to
condensation. Dry the bottom of the tank with a cloth. Dirt and residue in the tank can mean the
URS600CE takes longer to heat up and could damage the tank.
Please note!
Acidic or chlorinated solvents can cause corrosion to the stainless steel distillation tank.
This manifests itself as black pits in the distillation tank. Excessive corrosion leads to an unsafe situation
with leakage as a result. Check the tank after each process. In case of excessive corrosion, contact the
service/repair department of Uni-ram Corporation.
3.9. Check the lid gasket and replace if necessary
Check the lid gasket before use for shrinkage, hardness, cracks or other damage. The lid gasket wears
out because it is exposed to high temperatures and solvent vapours during the recycling process. Damage
to the lid gasket can lead to leakage of solvents. Replace the lid gasket, at a minimum, every 6 months.
See chapter 4.3 "Replacing the lid gasket" of this manual for instructions about replacing the lid gasket.
Please note!
Make sure you always have a spare lid gasket in stock. One additional lid gasket is included
with the purchase of the URS600CE.
