15
MANUAL - SOLVENT RECYCLERS - URS1600 SERIES, URS2000 SERIES & RI 80 Rev 2019-05
SERVICE PROCEDURES
1) CLEAN CONDENSER
Remove the 2 screws at the back of the Side Cover and carefully move the Side Cover forward just
enough to reach the front of the condenser with a vacuum. Using a brush attachment, vacuum the front of
the condenser where most of the dust accumulates and then vacuum the back if necessary. Put the Side
Cover back into position and re-install the screws.
2) CLEAR BLOCKED SOLVENT FLOW PATH
CAUTION:
WEAR SAFETY GOGGLES.
A blockage in the solvent fl ow path (Vapour Outlet - Condenser - Solvent Outlet Tube) can cause solvent
to leak. To determine the location of the blockage, fi rst check the Solvent Outlet Tube and the Vapour
Outlet Fitting for visible signs of blockage or damage. If the problem is not in either of these locations, the
Condenser is problably blocked. To clear the condenser, pour some clean solvent into the Vapour Outlet
and check if it comes out of the Solvent Outlet Tube. If the blockage persists, blow air at about 30 PSI (2
kg/cm2) into the Vapour Outlet. If the air comes out of the Solvent Outlet Tube, the blockage has been
cleared. If not, call for service.
3) REPLACE FUSES
Fuses are located on the Power Control Board inside the Motor Housing.
• Disconnect power supply.
• Remove the Guard Screen by unscrewing two metal screws to get access to the Motor Housing
• Unscrew the 6 screws from the Front Cover and pull it gently from the motor housing to expose the
fuses.
Note: Care should be taken not to pull the Front Cover too far as some wires may discon-
nect.
Fuses F1 & F2: 240 VAC, 20A (URS2000) or 30A (URS2000PW & RI 80), 3AG, fast action, for Heater
Fuses F3 & F4: 25 VDC, 2.0 A, 3AG, slow action, for Fan Motor
Fuse F5: 240 VAC, 0.0625 A, 3AG, fast action, for Computer Board
• Remove the fuses from the board and, using a meter, test each one and replace as needed.
• Carefully push the Power Control Board back into the Motor Housing.
• Ensure that the wire to the computer board is secure.
• Re-install the Front Cover using all 6 screws..
• Install the Guard Screen using two metal screws.
• Close the Door and re-connect the power supply.
Motor Housing
Power Control Board
Front Cover
