AP01 HD rev.09 UK
24
4.8.2.
DiSEqC
Pressing the
DiSEqC
key, commands selected in the below menu are alternatively
transmitted. The DiSEqC command can be transmitted only if the LNB is powered (also with
0 V voltage).
4.8.3.
DiSEqC ENGAGED MENU
Keeping the
DiSEqC
key pressed,
the menu to select the use of DiSEqC commands is
displayed on the screen.
•
DiSEqC 2 WAYS: to set the use of 2 preset commands for the universal switches
(TONE BURST and DATA BURST). Press the
ENTER
key
to transmit the two
commands.
•
DiSEqC 4 WAYS: to set the use of 4 preset commands (SAT A LNB1 - SAT B LNB2 –
SAT C LNB3 – SAT D LNB4). Press the
ENTER
key to transmit the four commands.
•
DiSEqC LEV. (1.1): to choose between - level 1.1 (only transmission)
- level 2.0 (transmission and reception)
•
DiSEqC LIST: to display the complete table of DiSEqC commands.
To select and transmit a DiSEqC command from the list, turn the
SHAFT ENCODER
to move to the desired command, then press the
ENTER
key. Once the command
has been transmitted, this will be stored on the first box of the list.
•
DiSEqC USER: to activate setting of four commands (USER1, USER2, USER3, USER4)
whose code is established by the user.
Move to the desired item and press the
ENTER
key; then type on the keypad the
code to insert. For alphabetic characters use the related function of the keypad.
To use these commands, select them from the DiSEqC LIST menu.
PLEASE NOTE:
It is possible to transmit the latest used commands pressing the
DiSEqC
key,
with no need to
enter the menu functions.
•
MOTOR (1.2): to display a bar with the following five commands:
1.
START: it enables the following functions:
Start East: to start rotation to East direction;
Start West: to start rotation to West direction;
Press
ENTER
to transmit the selected command.
Start East for T (xx): to start rotation to East direction for an established time T
(sec.);
Start East for S (xx): to start rotation to East direction for an established number of
steps S.
Start West for T (xx): to start rotation to West direction for an established time T
(sec.);
Start West for S (xx): to start rotation to West direction for an established number of
steps S.
Press
ENTER
to highlight the box (xx) to enable setting the desired value, turning
the
SHAFT ENCODER
. Press
ENTER
again to transmit
the command.
Exit: to exit menu.
