umbratek ADRA DD Series, Руководство пользователя

Страница: 32 / 52

EN Ver. 0.2.0
32 / 52 © 2022 Umbratek All Rights Reserved.
Firmware Update
Upgradeable actuator firmware and multiturn encoder firmware. Multiturn encoder firmware normally
does not need to be upgraded. You can view the current actuator firmware version in Software
Version under Firmware, and determine whether to update the firmware based on the firmware
published on the official website.
Firmware Upgrade Interface
Online Upgrade Actuator
1. Click
①
“ Upgrade Driver ” to upgrade the firmware as prompted.
2. After entering the upgrade mode, the LED will blink quickly. After about 3 seconds, the LED will blink
slowly, indicating that the upgrade is in progress. After the upgrade is complete, the indicator turns to
breathing. (If the indicator still blinks slowly, determine whether the upgrade is complete according to
the prompts of the software.)
3.
Do not power off or disconnect communication during the upgrade. Otherwise, the upgrade may
fail or the online firmware upgrade cannot be restored.
4. After upgrade, please power on the actuator again and check parameters that has been set. You
may need to reset parameters if the previous setting has been cleared.
Abnormal situation
1.
If the online upgrade fails due to an interruption during the upgrade, you can use the local upgrade