Ulvac GI-M2, Инструкция по эксплуатации

Страница: 40 / 101

34
8.14.Setting of Activated Filament
（
GI-N8 only
）
→
Refer to
Ｐ．
34
Here, the filament activating action is set.
Filament activating action invalid (OFF) : Act_1
Filament activating action valid (ON) : Act_2
Ａｃｔ－①
The
○
portion in the left figure blinks.
Each time the [
∆
] key is pressed, the
numeric value of the blinking portion
changes [
・・⇒１⇒２⇒１⇒・・
].
When a desired value is displayed, press
the [
⇒
(ENTER)] key to transfer control
to the BPS-
①
status.
If filament activating action valid (ON) is specified here, exit the set mode, press the Fil
key to perform activating action. A second press on the Fil key stops activation.
Activation will automatically end in about 30 minutes, when measurement is ready.
8.15. Setting of Baud Rate
→
Refer to
Ｐ．
65
Setting of Baud Rate of
Ｒ
S
－２３２Ｃ
.
ＢＰＳ－①
The
○
portion in the left figure blinks
after the segment indicator displays [
ｂ
ＰＳ ＿＿
] for about 1 second. Each
time the [
∆
] key is pressed, the
○
portion of the segment indicator displays
[
９６ ００
]
⇒
[
１９２ ００
]
⇒
[
３８４
００
]
⇒
[
９６ ００
]
・・
cyclically.
When a desired value is displayed,
press the [
⇒
(ENTER)] key to transfer
control to the SEN-
①
status.