2
Safety instructions
Electrical
Connect to a 220-240 VAC fully earthed supply via a 3pin plug.
It can be dangerous to operate an ultrasonic bath without an earth connected.
The mains plug is fitted with a 5A fuse.
NEVER FIT A FUSE OF A HIGHER RATING.
Ensure that excess mains cable is stored neatly.
General use
Ensure that the bath contains liquid before you switch it on.
Always fill with cold water. This will ensure that the
Hygea 6427
always runs its
automatic de-gas cycle (see pg 29 for the importance of degassing).
Do not place fingers or other parts of the body in the bath.
Always use a basket to support items to be cleaned.
Not doing so may damage the bath and invalidate your warranty.
Care should be taken when operating the bath at higher temperatures as external
surfaces may become hot.
For best cleaning results use a detergent, at a suitable dose, recommended for use in
ultrasonic cleaning baths. Never use toxic, flammable, acidic, caustic or corrosive
solutions in the bath.
Refer to the
Hygea 6427
Operator Instructions
manual for full guidance on the correct
use of the bath.
The user should familiarise themselves with this
Operator Instructions
manual before
operating the equipment and should apply to Ultrawave or its agent for advice on cleaning
techniques or detergents. Ultrawave will not be responsible for damage or injury caused
by incorrect use of the equipment.
Ultrawave will not be responsible for damage or injury caused by incorrect use of the
equipment.
