Ultimate GHARGER PRO-8, Руководство пользователя

Страница: 20 / 32

18
This program is for charging and discharging of NiCd/NiMH batteries associated
with R/C models applications.You can press”Start/Enter”key to make it blink and
then INC or DEC to change the parameter value.Press”Start/Enter” key to store
the value.
This program charge the battery using the current you set up.In the "auto" state,
you should set up the upper limit of the charge current to avoid damage by
excessive feeding current. Some batteries of low resistance and capacity can
lead to higher current in the"auto"charging mode. But in the manual mode, it will
charge with the current you set. You can make it blink in the current field and
press”INC ”or” DEC” at the same time to switch mode.
The screen shows the real-time status.Press”Batt.type/Stop” key to end the program.The sound will emitted
to indicates the end of program.
Set charge current on the left and the final voltage on the right.Range of the
charge current is 0.1-2.0A;range of final voltage is 0.1-25.0V.Press”Start/
Enter”key for more than 3 seconds to start the program.
The screen indicates the discharging state.You can press ”Start/Enter” key to
alter discharge current. Press ” Start / Enter ” again to store the value. Press
”Batt.type/Stop”key to stop discharging.The emitted sound alerts the end of
discharging.
The 4th cell was damaged.The value of voltage may be zero if disconnection
occurs.
GHARGER PRO-8