ULS VersaLaser VL-200, Инструкции по безопасности и установке

Страница: 64 / 77

Figure 1 (Front View)
1. Four “foot” ports to secure the
VersaLASER to the cart and prevent
slipping (1)
2. Pre ‐ filter and HEPA filter drawer
3. Charcoal filter drawer
4. Locking casters
Figure 2 (Rear View)
1. Exhaust intake port
2. Cable retainer clips
3. USB port
4. Exhaust output port
5. Power inlet, electrical power requirement
label, Warning label, fuse holder
How it works
This device contains a pre ‐ filter to remove coarse (larger) particulates, a HEPA filter to remove fine
(smaller) particulates, an activated charcoal filter to remove fumes and odors, and a high ‐ pressure
vacuum motor to pull these byproducts through the filters. It also serves as a moveable base, or stand,
for the VersaLASER. To reduce noise, minimize electrical consumption, and prolong filter life, the CCAC
is controlled from the VersaLASER via a USB cable. The VersaLASER powers on the CCAC when
processing begins and powers it off a few seconds after the processing completes to remove any
remaining particulates, fumes, or smoke.