ULS VersaLaser VL-200, Инструкции по безопасности и установке

Страница: 72 / 77

Installation
Lower the table down far enough so that you can
attach the cone. Power off the VersaLASER. By
hand, move the X ‐ axis arm and Focus Carriage to a
comfortable working position in the field. Remove
(if present) the plug (1) with a screwdriver.
Using a 3/16 socket tool or 5mm wrench, attach
the needle valve to the port where you removed
the plug. Be careful not to cross ‐ thread the small
device when installing and do not over tighten it.
Loosen the thumbscrew (1) on the side of the
Focus Carriage (if already attached). Insert the
cone (2) by pushing it straight up into the bottom
of the Focus Carriage ensuring that it is up all the
way and is seated properly, and gently tighten the
thumbscrew. If this is the first time using the
cone, open the needle valve (3) all the way,
counter clockwise. This will result in maximum
airflow through the cone. To lock the adjustment
in place, rotate the round locking nut (4) clockwise
until it seats.
Usage
Power on the VersaLASER and run a job. Make sure that the CCCAU unit turns on (if purchased) or your
compressed air source is operating when the job starts processing. Observe how the smoke is pushed