ULS VersaLaser VL-200, Инструкции по безопасности и установке

Страница: 32 / 77

reads “Fontrasterizer=1”. Change the 1 to a 0 (this is a zero, not an o), save the file, and exit
Notepad.
3. Open CorelDRAW12 and start a new graphic.
4. In the menu bar, click on “Window”, then “Color Palettes”, and then click “None”. Once again
click “Window”, then “Color Palettes”, and then “Open Palette”. In the pop ‐ up box, double ‐ click
on "VersaLASER.CPL" which allows it to appear on the right side of the screen.
5. On the property bar, click on the landscape orientation (the sideways rectangle). Enter the page
width of 16 inches (406.4mm) (model VL ‐ 200) or 24 inches (609.6mm) (model VL ‐ 300) and
height of 12 inches (304.8mm).
6. The rulers on screen need to match the rulers in the VersaLASER. Adjust the ruler's vertical
origin by double ‐ clicking directly on the vertical (side) ruler. The “Options” dialog box will
appear. In the vertical origin box, type in 12 inches (304.8mm). Click OK
7. Set the default value for line width and color of the graphic objects, by clicking the outline tool
and then the outline pen dialog in the flyout. With “Graphic” being the only selection checked,
click “OK”. Click the down arrow in the Color dropdown box to expand the list and click on the
color red. Click the down arrow in the “Width” dropdown box and click “Hairline”. The units
can be “inches”, “millimeters” or anything else you prefer. Click “OK to close the Outline Pen
dialog box.
8. In the top menu, click “Tools, then click “Color Management”. Click on the down arrow to
expand the “Style” dropdown list. Click “Color Management Off”, and then click “OK”.
9. Finally, at the top of the screen, click on “Tools”, then “Options”, then “Document”, and then
select “Save Options as Defaults for New Documents”. Make sure ALL the options listed are
CHECKED then click “OK”.
10. The setup defaults for CorelDRAW12 are now complete. Whenever you start a new document,
all of the default settings that we had setup will automatically apply to the new document.
Remove the VersaLASER Installation CD ‐ ROM from your CD ‐ ROM drive and store it either back into
the pocket of the rear cover of the manual or in a safe place.
Section 3
Operation