ULS VersaLaser VL-200, Инструкции по безопасности и установке

Страница: 47 / 77

Beam Window

The Beam Window is where the laser
beam enters into the processing area. It
is located in the upper left hand corner,
towards the rear of the machine.

It is only necessary to clean the front side
of the Beam Window. The backside is in a
sealed environment and should not get
contaminated.

DO NOT remove the Beam Window for
inspection or cleaning. Inspect the optic
in place and clean if necessary.
1. Beam Window
The Motion System

Using a vacuum cleaner, vacuum all loose dirt and debris from the inside of the device.

Outside the device, dampen a paper towel, cotton cloth, or terry cloth with the soap solution,
alcohol, or acetone and wipe down the Z ‐ axis Table. Be careful not to spill any chemical on any
painted surface.

Locate the four X ‐ axis Bearings (1).
Dampen a cotton swab with either the
soap solution or alcohol. Place the

Locate the left and right side Y ‐ axis Rails
and their respective v ‐ grooves as the
arrows in the photos indicate. This is