UINICS SP-564A Series, Инструкция по эксплуатации

Страница: 15 / 37

- 14 -
10. Setting the mode
・Calling up and modifying the mode setting
When a mode is set, operate each key according to the following table.
Operating key Display unit Operation procedure
MODE + ＞
Ａ Ｂ Ｃ Ｄ Ｅ Ｆ
０ １.
１ ０ ０ ０
↑
Mode No.
While holding down the MODE key, press the
＞ key for 2 seconds or more.
“0 １ ” appears in displays A-B and the value
setting
for mode 0１ is shown.
∧
Ａ Ｂ Ｃ Ｄ Ｅ Ｆ
０ １. １
０ ０.０
↑
0 to 9
Change the blinking numeral value. Every press
raises the value by ones.
(0 → 1 → 2・・・9 → 0・・・)
∨
Ａ Ｂ Ｃ Ｄ Ｅ Ｆ
０ １. １
０ ０.０
↑
0 to 9
Change the blinking numeral value. Every press
reduce the value by ones.
(0 → 9 → 8・・・1 → 0 →9・・・)
＞
Ａ Ｂ Ｃ Ｄ Ｅ Ｆ
０ １. １
０ ０ .０
→ → →
Change the blinking indication position (figure).
Every press moves the position to the right
by a figure.
MODE
Ａ Ｂ Ｃ Ｄ Ｅ Ｆ
０ ２.
３ ０ １ １
↑
01 to 16
Change the mode number. Every press raises the
number by one. There are 16 modes in total.
When it reaches 16, it returns to 01.
(01 → 02 → 03・・・16 → 01・・・)
ENT
After adjusting the setting, make registration
with this key. It returns to the measuring mode
after registration.
RES
Even by pressing this key during the time
setting the mode, it returns to the measuring
mode. Pay attention to the fact that the set
data is not memorized.
Note ： In case you change mode setting, turn OFF mode protect.
If it is turned ON, change of mode setting will be made impossible.
（Refer to 27 page.）
∨ Activated for 2 sec or more ・・・
Mode protect ON “Ｌ－ＯＮ”
Mode protect OFF “Ｌ－ＯＦＦ”