Page 8
37360 Instruction Manual (Rev. 0)
4.7
Installation of CUB software
The CUB software is contained in the USB pen-drive provided with the instrument. Install
it on your PC.
At the first installation, a code will be generated: send the code to
registra-
to receive an
activation key
.
From the installation, you have 30 days to enter the activation key; when the 30 days trial
period expires, it will not be possible to activate the software and it will be necessary to
uninstall and install it again (ask for instruction at our Customer Support, see paragraph
10.5).
4.8 Intended
Use
The Tail Flick Unit is intended for investigation use on laboratory animals only.
4.9 General
Safety
Instructions
The following guidelines must be followed to ensure safe operation.
DO NOT
attempt to open or perform any service work
DO NOT
connect up human subjects
4.10 Additional
Safety
Consideration
a.
Place your Tail Flick on a flat surface;
b.
Do not obstruct free and comfortable access to the power module;
c.
Use original accessories and spare parts only, see also paragraph 12-
ORDERING INFORMATION
d.
Immediately disconnect and replace a damaged mains cable;
e.
Do not operate the instrument in hazardous environments or outside pre-
scribed environmental limitations (i.e. +18C°/+24C°, 60% relative humidity,
non-condensing);
f.
Do not spray any liquid on the connectors;
g.
Keep inflammables far from the heating source.
UGO BASILE DOES NOT ACCEPT ANY RESPONSIBILITY FOR PROBLEMS OR
HARM CAUSED TO THINGS OR PERSONS, ARISING FROM:
incorrect electrical supply;
incorrect installation procedure;
incorrect or improper use or, in any case, not in accordance with the purpose
for which the instrument has been designed and the warnings stated in the in-
struction manual supplied with the instrument;
