UFO Comet Light Source, Руководство пользователя

Страница: 9 / 24

INSTALLATION
9
UFO LIGHTING
CONNECTION
-
FOR 1-10 V ( CURRENT SINK ) OPERATION
-
CONTINUED
Plug the power supply’s output into the Comet’s power supply input and then connect the
mains plug into a local mains supply. The Comet will initialise and display its current status.
Consult the Troubleshooting and Operation sections in this manual if the Comet does not
power up or operate as expected.
1-10V NOTES
• This is a current sink 1-10V control system. A 10V output from the Pulsar is connected via an
external 1-10V current sink dimmer varying the circuit current to control the dimming only
• Dimming is controlled between maximum light output and approximately 10% at minimum
light output. This minimum value may vary depending on the dimmer used
• Always use an approved CAT5 cable
• Always ensure correct connection polarity
• The Comet 1-10V dimming system has been designed around the UFO CVD3 Current Sink
Electronic Dimmer (See Accessories in Technical Specification section at end of this
document)
• The CVD3 is designed to be fitted to the back of a one gang faceplate