UBCO 2x2 Dual-Use 2018, Руководство пользователя

Страница: 28 / 57

25
Warning Light
If there is a problem with one of the systems, the
warning light on the display will flash and an error
code will be displayed in the odometer area on the
screen. For information on the error code, including
possible causes and solutions, refer to your UBCO
2×2 App.
Reading Your Power pack Level
The power pack display is split up into 12 segments
with a halfway indicator between the 6th and 7th
segments.
The power pack level is based on power pack
voltage. The meter may temporarily drop when the
2×2 is under high load or high acceleration; this is
caused by “voltage sag” and does not indicate the
level of remaining charge is dropping quickly. The
power pack level meter will recover when the load
on the motors is reduced.
Changing the Time
Your LCD screen comes equipped with a clock, so
you can keep track of the time while you’re out and
about. To change the time, follow these steps.
a. Hold down right button until numbers flash.
b. Press the right button to change between hours
and minutes.
c. Press or hold down the left button to cycle
through numbers.
Odometer and Trip Meter
To select between odometer and trip meter view,
press the left button.
To reset the trip meter, press the left button for 7-8
seconds while in the trip view mode.
Switching from Metric to Imperial
To select between metric and imperial units for
the speed, odometer and trip meter, while ODO is
showing, hold down the left button.
To change between metric and imperial units for
the motor temperature, press the right button on
the display.
Power Output Meter
The power output meter on the LCD screen
displays the real-time power output to the motors.
Any bars shown above the 0 mark represent
power output to the motors, and any bars shown
under the 0 mark represent power input by the
motors through regenerative braking.