UBCO 2x2 Dual-Use 2018, Руководство пользователя

Страница: 34 / 57

31
Charging Your Power Pack
How to charge the power pack:
a. Turn off the 2×2 and remove the key.
b.
Plug the provided charger into any standard
wall socket and switch on at the wall.
c. Plug the charger into the power port on the
console and twist to lock.
d. The LED indicator lights on the charger will
signal:
A
GREEN: Power pack is full or disconnected
A
RED – Solid: Charging
A
RED – Flashing: Charge error
If a charge error occurs, disconnect the charger
from the power pack and wall socket. Reconnect. If
flashing persists, contact your service provider.
Charger Settings
The charger has two settings: Max and Normal.
The recommended setting is Normal.
•
Normal Setting: Charges the power pack to
90% capacity. This setting is ideal of those not
using a full discharge and will extend power
pack life.
• Max Setting: Charges the power pack to 100%
capacity. This setting is useful for high intensity
environments and those that require maximum
daily range.
When charging:
A
Keep away from any sparks or flames.
A
Install a smoke alarm near your charging area.
A
Do not charge if cables, charger, or power
pack are damaged.
A
Use charger in dry, indoor conditions only
and with adequate ventilation.
Checking Power Pack Charge
To check the capacity of your power pack, ensure
the power pack is plugged in to the 2×2 and turn
the key to ACC or RUN. The power pack meter
display on the left hand side of the LCD display will
indicate the remaining charge and will flash when
the charge gets low.
The yellow ‘Charge Required’ light at the top of
the display will also illuminate when the remaining
charge is low.