U.S. Solid USSOILP1, Руководство по эксплуатации

Страница: 7 / 20

For questions or concerns, e-mail service@ussolid.com, visit www.ussolid.com, or
call (800) 209-4177
1. Place oil press on solid level table.
2. Install hopper according to Figure 2. Place the oil cup below
the oil outlet and prepare container for slag.
3. Plug in power supply that corresponds to the socket on the
machine.
4. Installation is complete.
Manufacturer tests machine before shipping and then thoroughly
cleans the item. When cleaning yourself, be sure to avoid abra-
sive materials (toothpaste, etc.), acid, and alkaline liquid (such as
soda water). After cleaning, please be sure that pressing chamber
and screw are totally dry. Moisture can make material stick on the
screw and produce a metal friction noise.
IV. Installation
V. Operating the Machine
The oil press can do two types of pressing: hot pressing and cold
pressing. Before beginning this process, user must make sure raw
materials are dry enough for use. For highest quality oil, only high
quality, fresh raw materials should be used for pressing.
Cold Pressing
If the materials are sufficiently dry, they do not need to be heated.
Preheat the machine for at least 20 minutes, though more time
may be necessary in the winter. Directly put the raw materials in
the hopper.
Hot Pressing
Preheat machine for at least 25 minutes. Heat seeds starting with
5-7 ounces at a time and blot dry before adding to the hopper.
Do not allow seeds to cool as this will create more slag and possi-
bly cause a blockage in the pressing chamber.
Note: The aim of heating is to remove excess water and improve
the concentration oil. Begin pressing after the raw materials are
well heated. If the seeds are overheated,a paste or powder will
come out, and the pressing chamber will make a friction noise.