U.S. Solid USSOILP1, Руководство по эксплуатации

Страница: 17 / 20

For questions or concerns, e-mail service@ussolid.com, visit www.ussolid.com, or
call (800) 209-4177
Problem: The electric motor buzzes and shakes.
Cause:
• The motor is jammed.
Solution:
• Stop pressing immediately and remove raw material from
hopper. Preheat for one hour and then press “Clean” for up
to two seconds ,then press “Start” for one second. Repeat
and the lever will ease out. If still stuck, take out the press
barrel, put it on the gas stove over a low flame, and dry the
dross hole (6 cm long) of the press barrel until raw materials
inside are burnt up. In the process, you will hear a squeaky
sound. Then you can reinstall the press barrel on the oil press,
screw on nuts, and press “Clean.” USE CAUTION to avoid
burns and bodily harm.
Problem: The machine is making a sharp metallic noise.
Cause:
• Materials are not entering the barrel evenly. You should allow
it to continue to run two or three minutes and the noise will
disappear as the raw materials redistribute in the press barrel.
If the metal friction sound still occurs, then the raw materials
are damp and sticking to one side of the screw.
Solutions :
• If raw materials are only partially damp, you can counteract
this by adding soy beans to draw out moisture from the raw
materials until the sound disappears.
• Remove the press barrel, clear away the raw materials that
are stuck on the screw, and then dry the barrel.
• Replace moisture retaining raw materials with heated raw
materials(according to the above method of heat pressing).
Problem : Powder begins coming out during the middle of the
pressing process.
Causes :
• Too much raw materials was heated at one time.
• Raw material was allowed to cool after heating.
Solution:
Heat about two pounds each time. When the pressing is about
to finish, you can heat a new batch. Cover raw materials when
pressing, especially in winter.