U.S. Products SOLUS-500, Информация и инструкция по эксплуатации

Страница: 14 / 21

4
KNOW YOUR MACHINE
VACUUM LID
- This lid provides access into your recovery tank so that you can clean the tank. The lid
must be closed before you try to clean..
SOLUTION TANK FILL HOLE
- This is where you fill the tank with water and cleaning solution.
VACUUM HOSE BARB
- This is where you connect your vacuum hose to the machine. A tight connection is
necessary to prevent a vacuum leak which would reduce the amount of suction.
DRAIN HOSE
- This is how you empty the dirty water from your recovery tank. Place the hose over a drain,
and open the cap. When cleaning out the tank at the end of a job, simply place this hose into a drain and
use clean water to rinse out the dirt and debris from the tank.
NOTE : be sure to close the cap tightly before
using the machine again.
HANDLES
- The handles are used to move the machine. These handles allow you to tilt the machine back
onto it’s 12” wheels for easy maneuvering, and/or for moving on stairways.
SWITCH PLATE
- The switches are located on the rear of the machine, out of the way of water
FAN
- Removes warm air from the component compartment.
PSI GAUGE
- indicates the pump pressure. Look at the pressure while you spray.
LATCH
- The latch holds together the tank and the base compartment.
SOLUTION HOSE QUICK COUPLING
- This is where you connect the solution line that runs from the
machine to the carpet wand or hand tool.
POWER CORD RECEPTACLES
- The receptacles are where the two power cords connect to the machine.
CASTOR
- Swivel castor provides easy maneuverability.
WHEEL
- The rear wheels are 12 inches in diameter to provide superior ease of transportation and stair
climbing.
DRAIN
HOSE
HANDLES
VACUUM HOSE
BARB
FAN
POWER CORD
RECEPTICLES
VACUUM
LID
LATCH
SOLUTION HOSE
QUICK COUPLING
SWITCH
PLATE
CASTOR
SOLUTION
TANK FILL HOLE
PSI
GAUGE
12” WHEEL