25
④
Function Introduction
99%X2GB~101%X2GB)
➡
1.98GB~2.02GB
Source
Target tolerance setting:±1%
Real capacity 2GB 2.02GB (2GB+1%) 1.93GB (2GB-1%)
●
No limit: there is no any limit on capacity between the source and target. Please
be noted that, under this model, if the data size in the source is over the capacity
of target, it might lead to incomplete copy.
●
100% Same: The capacity of targets has to be exactly the same as the source, or
it will not able to execute any function.
7.6 Asynchronous
You can select "Disable" to close Asynchronous copy or "Enable" to open the function.
If the setup is "Enable", and the data in source is smaller than system buffer memory,
it will automatically use asynchronous mode to do copy. If the setting is "Disable", no
matter what the content size is or copy method, the system will keep synchronous
copy.
7.7 Check Before Copy
You can select if you would like to check the media before copy.
7.8 Power Off Time Between Copy&Compare
To prevent from any data loss problem of unstable flash, we strongly recommend you
to follow function 7.8 to set the time gap of power supply between copy and compare.
The setting range is from 0 to 15 seconds, and the default setting is 3 seconds.
7.9 Language
Set system language interface.
