23
④
Function Introduction
•
After finishing calculating, there will be an 8-digit value produced.
7.
System Setup Function
7.1 Start-up Menu
You can select which function is shown first when the duplicator is turned on.
7.2 Copy Area
7.2.1. System and Files
This is also called "quick copy" mode. The system will automatically analyze the source
flash card's file format. If the data's file format is FAT16/32, NTFS, Linux (ext2, ext3,
ext4) which is recognizable by the system, it will be able to copy data only instead of
the whole flash. Otherwise, if the file format is non-recognizable, the system will copy
the whole flash card including the empty space. For example, a 2GB flash card which
is FAT32 file format and has only 50 MB data inside, the system will only copy that
specific 50 MB of data, it takes only a few seconds to copy the source.
Note
If the source format is NTFS or Linux, to make sure the target could be operated normally,
the target capacity must be equal or bigger than the source device.
7.2.2. Whole Media
Setup the duplicator in Whole Media function, the system will copy the whole flash
card, including the empty space and format. This function is used when you have a
flash source which has an unknown file format. For example, a 2GB flash card which is
FAT32 file format and has only 50 MB of data inside, if you setup "Whole Media", the
system will copy whole 2GB of Flash. It will take longer time to copy the source.