
PAGE OF 8
INSTALLATION
ELECTRICAL REQUIREMENTS
CAUTION! Follow local electrical and safety
codes as well as the National Electrical
Code (NEC) and the Occupational Health
and Safety Act (OSHA).
The machine is rated at 0 to 25 volts AC, 50/60
hz with a ground. At this voltage the unit draws
about 5 amperes. The use of extension cords is not
recommended.
Locate the unit at or near an appropriate electrical
supply. Be certain that the power source conforms
to the machine’s requirements and that the proper
gauge and type of wire is used. Make connections
using the shortest possible runs of wire. Long runs of
wire can result in reduced voltage.
CAUTION! ALWAYS check the specifications
listed on the back of the machine. It shows
the correct operating voltage and amp
draw for this machine.
GROUNDING
For your SAFETY and machine protection, DO NOT
operate without a proper and secure electrical
ground. If a grounded receptacle is not available,
use a proper grounding adapter.
NOTE: All warranties are VOID if the
machine is used with an ungrounded
electrical connection. Never connect a
machine to any power source that exceeds
the specified rating.
LOCATION
CAUTION! DO NOT operate this machine in
explosive atmospheres. Do not subject the
machine to wet or corrosive environments.
Keep all flammable and caustic
substances away from the machine at all
times.
Unit is for indoor use only. Select a location close
to where the products being packaged are stored
or manufactured for best workflow. Also consider
whether the operator will sit or stand while using
this machine. Place the unit on a level, sturdy
table that can support the weight of the machine,
the products to be packaged and those already
packaged.
DESCRIPTION
This self-contained bag-packaging machine
dispenses, opens and seals pre-made, pre-
opened bags from a roll. The chassis is 00 series
stainless steel and is designed as a tabletop unit
to be used in the vertical position. The machine
works with pre-made, pre-opened bags on a roll
up to a maximum 2” (0.5 cm) wide and up to
2” (0.5 cm) long. Running longer than maximum
bags may require factory modifications. heavy
products may also require factory modifications.
NOTE: Continuous pre-made bags-on-a-roll
that are not pre-opened will not work on
this machine.
The Bag On A Roll Machine is extremely safe and
easy to use even by inexperienced operators.
There is no guesswork, and the machine is designed
for the SAFETY of both your operator and your
products. If the sealing jaws encounter anything
significantly thicker than the bag to be sealed, no
heat or pressure is applied – protects operator’s
hands and fingers.
The electromagnetic jaw pressure system exerts
pressure only after the sealing jaws close. The
adjustable sealing system provides heating and
cooling time to make consistently strong heat
seals. Once the heat-sealing cycle is complete,
the sealing jaws reopen.
HOW THE MACHINE WORKS
Install the pre-made, pre-opened bags on a
roll in the machine.
Close the pinch rollers.
Set the bag length control for the proper time
duration.
.
2.
.