![background image](http://html1.mh-extra.com/html/u-line/h-10066/h-10066_manual_3124765011.webp)
PAGE 11 OF 13
0922 IH-10066
MAINTENANCE CONTINUED
CLEANING/REPLACING DRIVER BLADE
DISMANTLING DRIVER BLADE
1. Remove battery from stapler.
2. Remove magazine.
3. Set penetration depth to MIN.
4. Loosen six captive Torx cylinder screws (1) holding
the rear body to the front section. (See Figure 25)
2
Figure 25
1
3
4
5. Pull down the rear body (2) and remove it.
6. Remove driver blade (3).
7. Clean and check driver blade for wear. Replace
if necessary.
FITTING DRIVER BLADE
• Fitting is performed in reverse order.
• When installing driver blade, ensure the "visible
while assembling" signage (4) points outward.
(See Figure 25)
CLEANING/REPLACING CLINCHERS
DISMANTLING CLINCHERS
1. Remove battery from stapler.
2. Remove magazine.
3. Set penetration depth to MIN.
4. Loosen six captive Torx cylinder screws (1) holding
the rear body to the front section. (See Figure 26)
4
3
Figure 26
2
1
5. Pull down the rear body (2) and remove it.
6. Remove two Torx cylinder screws (3) and remove
clinchers (4).
7. Always change both clinchers at the same time.
8. Clean and check clinchers for wear. Replace if
necessary. (See Figure 26)
FITTING CLINCHERS
Fitting is performed in reverse order.
REQUIRED PARTS
MFG. PART #
c.561B / c.561B22 Driver Blade (wear part)
164175
M4 Torx Cylinder Screw (1)
946876
REQUIRED PARTS
MFG. PART #
c.561B / a.560B Clinchers (wear part)
134340
M4 Torx Cylinder Screw, Housing (1)
946876