– 9 –
– 10 –
21. extension cords
• use only extension cords that are intended
for outdoor use. these extension cords are
indentified by a marking
"Acceptable for use
with outdoor appliances; store indoors while
not in use."
use only extension cords having
an electrical rating not less than the rating of
the product.
Refer to chart on page 21.
do
no use damaged extension cords. examine
extension cord before using and replace if
damaged. do no abuse extension cords
and do not pull on any cord to disconnect.
Keep cord away from heat and sharp edges.
Always disconnect the extension cord
from the receptacle before disconnecting
the saw from the extension cord.
• Ground fault circuit interrupter (Gfci)
protection should be provided on the circuit(s)
or outlet(s) to be used for the tile saw.
receptacles are available having built-in
Gfci protection and may be used for this
measure of safety.
Features:
• cutting table marked in inches for precision cuts.
• 350mm cutting table provides more support during
larger cutting jobs than the standard 280mm
cutting tables.
Using MasterGuide:
1. Set the MasterGuide by positioning it at the desired
dimension on the measurement rail and firmly
tighten the horizontal threaded knob. when using
the attached ruler, the guide can be used to make
cuts betwen 45º and 90º. to adjust the cutting
angle first loosen the vertical threaded knob.
2. the guide can also be used without the ruler
attachment to make 90º cuts on either the left
or right edge. the guide contains multiple 45º
templates to allow diagonal cuts of common tile
sizes. Position the guide for a diagonal cut by
aligning the desired template along a diagonal
groove on the table. to remove the ruler first
remove the vertical threaded knob.
3. after positioning the guide, place the material flat
against the guide and the table measurement rail.
now you are ready to make your cut.
Making Miter Cuts (Using Miter Block):
1. for miter cuts, place the lip of the miter block on
the measurement rail, with the threaded knobs
facing you.
2. tighten the threaded knobs to secure the miter
block in place.
3. Place material onto miter block and you are ready
to cut.
viii. USING THE CUTTING TABLE
Figure 4
Cutting large tile
TTE250
can cut a
610mm
tile and
diagonally cut a
460mm
tile.
tte250 shown with optional drip trays.
Figure 3
Drip Loop
TOOL
Supporting
Surface
Power cord
drip loop
