– 21 –
– 22 –
xiv. ELECTRICAL MOTOR SPECIFICATION
*
the motor is designed to operate on either 110v or 230v
mains, but not both. refer to the name plate located behind
the motor for power requirements specific to your motor.
Recommendations:
• Before connecting the saw to a power source,
ensure that the voltages match.
• it is recommended that a
1 amp circuit
be used while operating this saw if equipped
with a 110v motor. if the saw is equipped with
a 230v motor, a
10 amp circuit
should be
used instead. this will prevent possible power
interruption or loss.
• always plug saw as close as possible to the power
source while operating. this will allow you to
receive optimum electricity.
WARNING:
To avoid permanent motor damage you must use
the correct extension cord. Never use more than
one extension cord at a time. Follow the chart
below for proper size.
AWG
GAUGE
no. 12
no. 10
no. 8
no. 6
LENGTH OF CORD
TTE250
1.1 kW
110V
7 m
15 m
22 m
–
Power
1.1 kw
Volts*
110 v
230v
Amps
13 amps
7.5 amps
Motor RPM
22,000 rpm
Cycle
50 hz
Phase
1
Class
f
Blade Shaft
3,420 rpm
TTE250
AL203
Brown
Brown
Brown
Motor
Green/Yellow
Green/Yellow
Brown
Blue
Green/Yellow
Blue
Blue
Blue
Switch
13
14
23
24
Water
Pump
1.1 kW
20V
30 m
45 m
76 m
–
