– 11 –
– 12 –
tyrolit tte250 requires very little maintenance.
however, keeping your saw clean and properly adjusted will
ensure optimum performance. take great care not to get
water into the motor. do no use pressure washer to clean
motor area.
1. Cleaning
• form a habit of cleaning your saw after each
use. to clean the water tub, remove drain
plug provided in bottom of tub. remove
saw including water pump from tub. remove
residual water and clean tub using soap and
water only. reinstall saw with pump into tub.
• to increase water pump life remove tile grit
by purging water. Pump with fresh water after
each use.
• with a damp cloth or sponge wipe clean the
guide rails and all other surfaces on the saw
where dust and debris has accumulated.
2. Transporting
• unplug the power cord and store it in the
empty, dry water tub. for convenience and
safety, the saw should be transported with the
main table
locked
, motor in upper position
and all adjustment knobs tightened.
3. Sliding Vertical Arm Assembly Adjustment
• Make sure that all rails and rollers are clean.
• if the vertical arm assembly does not slide
smoothly, it will require tension adjustment as
follows:
a. locate the two tension rollers mounted onthe
black base of the vertical arm assembly
furthest from the arm. use a wrench to loosen
the nyloc nut directly below each roller. use
another wrench to prevent the bolt on top from
turning.
See Figure 5.
B. use the horizontal set screw to adjust roller
tension against the rails. the rollers should
roll free but without side movement.
c. tighten nyloc nut when finished to secure
rollers in place. Be sure not to overtighten.
4. Table Roller Adjustment
a. loosen (4) hex screws on table top.
B. adjust tension on rollers by turning set screw
(on outside of table) until desired tension is
achieved.
DO NOT OVERTIGHTEN.
See
Figure 6.
c. re-tighten the (4) hex screws on table top.
check table movement and re-adjust if
necessary. table should roll free but without
side movement.
NOTE - Do not lubricate the guide rails. The presence
of oil or grease will cause an accumulation of dust
and dirt.
xix. CARE AND MAINTENANCE
For your safety before performing any maintenance on the saw turn off the power switch and unplug
the power cord.
WARNING!
NOTE - Whenever making tension adjustments to
rollers on the vertical arm assembly or table, the
stainless steel wire linking the two components
together should be disconnected first. Otherwise, it
will not be possible to determine which rollers will
require adjustment. See Section 5 for steps.
Set screw to adjust
roller tension
Nyloc nut is found
under the base
Figure
Assembly Roller Adjustment
Adjust table tension
through this set screw
Figure
Table Roller Adjustment
