– –
– –
vi. BLADE INSTALLATION
1. carefully raise the cutting head to its highest
position and secure it into place by tightening the
cutting head adjustment knob located in the front
of the saw, to the right of the power switch.
2. raise the blade guard to the highest position and
tighten the blade guard adjustment knob.
3. remove the blade shaft nut and outer flange.
4. Place the blade onto the shaft making sure that the
directional arrows are pointing in the direction of
rotation.
5. after making sure that the blade is firmly placed
against the inner flange, secure it into place with
the outer flange and blade shaft nut. Make certain
the nut is firmly tightened with the wrench provided,
but
do not over tighten!
7. lower the blade guard and tighten the adjustment
knob.
8. Slightly loosen the cutting head adjustment knob
and lower the cutting head to its lowest position,
and then tighten the adjustment knob firmly to hold
the cutting head in place.
WARNING: Setting the blade too high may cause
the blade to grap the material being cut, causing
damage and possibly injury.
vii. SAFE OPERATING PRACTICES FOR TILE SAW
1. use safety equipment - wear safety approved
hearing, eye, head and respirator protection.
2. read and understand the symbol definitions
contained in this manual.
3. read and understand all warnings and instructions
on the machine.
4. read all safety materials and instructions that
accompany any blade or accessory used with this
machine.
5. establish a training program for all operations of
this machine.
6. always provide a copy of this manual to the
equipment user. if you need extra copies call our
customer Service department.
7. always select a diamond blade according to the
manufacturers recommendation suitable for the
material to be cut. never use a blade having a
maximum operating speed lower than the “no load
r.P.M.” marked on the tool nameplate. do not
operate any saw without safety guards in place
or with a blade diameter larger than the maximum
For your own safety and the safety
of others do not attempt to operate this saw until you
have read and understand the general safety rules
for all power tools and the following additional safety
precaution unique to this saw.
WARNING!
The dust generated by cutting of
tile, marble, stone, bricks etc. can be injurious to your
health. Always operate machinery in well ventilated
areas and provide proper dust removal. Always wear a
dust mask approved for respiratory protection against
these types of dusts and mists.
WARNING!
Figure 1
