5 Acceptance and transportation
EN Floor grinding machine FGE 400
10
4.6 Checking electrical components
Only suitably knowledgeable, qualified profes
sional electricians may perform work on any
electrical components of the machine.
Risk of fire due to faulty electrical cables!
—
Check the mains cable and power plug regularly
for functional safety.
4.7 Final tasks
Either decommission the machine
—
Disconnect the power plug [2, Fig. A] from
the mains.
Reduce the projection if necessary:
—
Swivel the guide handle into the front posi
tion (over the drive motor) and lock it in
place (
!
Chapter 3.1, Fig. J/M/R).
or
—
Restart the machine
(
!
Chapter 3.1).
5 Acceptance and transportation
Follow the safety instructions in Chapter 2.
5.1 Machine acceptance
The packaged machine is supplied complete from the
manufacturer.
1.
Unpack machine and check the delivery slip to
make sure all parts are delivered.
2.
Check for any transportation damage.
3.
In case of damage, contact the transport com
pany promptly.
4.
Report any problems to the manufacturer imme
diately.
Complaints at a later date cannot be acknowled
ged!
5.2 Transporting the machine
The machine may only be transported if it has
been switched off and the ETX locating plate is
at a standstill!
Risk of injury from heavy loads!
Suspended loads can slide out of place, fall or
tip over and cause serious injuries.
Never walk under or reach under suspended
loads!
Raising and lowering the load must be performed
by two persons!
Do not raise loads any higher than necessary!
Prevent the load from swinging back and forth!
Keep sufficient safety distance.
Devices for transporting the unit have to be
rated to handle its full weight and dimensions.
Observe weight data on packaging or in the ac
companying documentation.
Do not lift any additional loads together with the
machine!
Wear safety shoes!
Wear safety gloves!
During transport, the guide handle [1, Fig. A/J]
must always be locked in posi
tion [3, Fig. G/M/R] with the clamping lever!
The crane hook or lashing gear may only be
attached at the specified position
[
!
Fig. J/M/R]!
The machine can be fastened to pallets to protect it
against damages. A relocation over shorter distances
is possible on the transport wheels.
1.
Switch off the machine (
!
Chapter 3.3).
2.
Fasten any loose parts to the machine.
3.
Either
(moving machine over short distances)
—
Move the machine to the respective loca
tion with the transport wheels [5, Fig. A/J]
and deposit.
