TYM T1054, Руководство оператора

Страница: 158 / 204

5 -
MAINTENANCE
lEd blINkINg by ErrOr COdE
If there is an error in the system, the status LED indicates this error by blinking in the specified setting.
● : ON ○ : OFF
►
faults
code
1phase 2 phase 3 phase 4 phase
○ : Pause
● : Flash
description
2 sec. first digit 1 sec. second digit
11
○ ● ○ ●
Indicates Circuit Fault of the Lift Arm solenoid for Raising
12 ○ ● ○ ●● Indicates Circuit Fault of the Lift Arm solenoid for Lowering
13 ○ ● ○ ●●● Indicates Short Fault of the Lift Solenoid for Raising/Lowerring
14 ○ ● ○ ●●●● Indicates Connecting Fault of the Exterior (Raise and Lower) control button for Raising
15 ○ ● ○ ●●●●●
Indicates Connecting fFault of the Exterior (Raise and Lower) control button for
Lowering
16
○ ● ○ ●●●●●●
Indicates power Supply Fault of the Lift Arm controller (In short Circuit to +10V)
17 ○ ● ○ ●●●●●●● Indicates power Supply Fault of the Lift Arm controller (In short Circuit to +10V)
22
○ ●● ○ ●●
Indicates Position Sensor Fault
23 ○ ●● ○ ●●● Indicates Setpoint knob fault
24 ○ ●● ○ ●●●● Indicates Upper limit knob fault
28 ○ ●● ○ ●●●●●●●● Indicates Control Lever(Lift / stop / lowering) Switch fault
31
○ ●●● ○ ●
Indicates Left Draft Sensor Fault
32 ○ ●●● ○ ●● Indicates Left Draft Sensor Fault
33 ○ ●●● ○ ●●● Indicates Low battery voltage fault (below+8v)
34 ○ ●●● ○ ●●●● Indicates Lowering speed control knob fault
36
○ ●●● ○ ●●●●●●
Indicates Position / Draft sensitivity control knob fault
44 ○ ●●●● ○ ●●●● Indicates Position Sensor needs calibration