
PowerSeries Pro Installation Guide
(approximately 210 lbs/ 95 kg). Select hardware suitable for the mounting
surface.
Recommended minimum screw size: M4 (#8) x 4, 25.4 mm (1 inch) long,
pan head.
To mount the enclosure, complete the following steps:
1.
Position the enclosure in the mounting location and mark the two top
screw holes and the tamper bracket hole.
2.
Remove the enclosure, then install the two top screws part way and an
anchor for the tamper bracket, if necessary. Do not mount the tamper
bracket directly into drywall.
3.
Hang the enclosure on the installed screws then mark the two bottom
mounting holes.
4.
Remove the enclosure from the wall and install the components in the
following order:
l
Plastic standoffs for alarm controller and optional modules
l
Tamper switch and bracket
l
Power supply, including GND connection for HSC3010C,
HSC3010CR, and HSC3030CAR enclosures (see diagram). Note
that the ground nut mounts from the back of the cabinet.
5.
Hang the enclosure on the top two screws again then fasten the tamper
bracket to the wall.
6.
Install the two bottom screws. Ensure that all four screws are securely
tightened.
7.
Install the alarm controller. For models HSC3010C, HSC3010CR,
HSC3030CAR and HSC3020C enclosures, use the supplied metal
standoff and screw in bottom-right mounting hole as indicated in
figure 2-1.
8.
Install optional modules and wire according to the instructions
provided with the module.
9.
Wire the tamper switch into any available zone. Configure the tamper
for normally closed (NC) supervision. Zone must be programmed for
24-hour latching or non-latching tamper.
10.
Install the batteries only after the enclosure has been permanently
secured to the wall.
The following diagram indicates the mounting location of the alarm
controller PCB, power supply module and tamper bracket inside the
enclosure.
Wall mounting HSC3010C/ HSC3010CR/ HSC3030CAR enclosures
The following diagram indicates the mounting location of the alarm
controller PCB, power supply module and tamper bracket inside
HSC3010C/ HSC3010CR/ HSC3030CAR enclosures.
Figure 1-1 HSC3010C, HSC3010CR, HSC3030CAR
enclosures
30.93cm
[12.28in]
35.50cm
[13.98in]
31.27cm
[12.31in]
16.69cm
[6.57in]
2.97cm
[1.17in]
2.57cm
[1.01in]
B
A
A Use metal standoff and screw in the pos-
ition indicated. IMPORTANT! Ensure
screw and standoff are tightly secured to
establish Earth ground connection for the
PCB.
B Tamper mounting location
Wall mounting the HSC3020C enclosure
The following diagram indicates the mounting location of the alarm
controller PCB, power supply module and tamper bracket inside the
HSC3020C enclosure.
Figure 1-2 HSC3020C enclosure
40.64cm [16in]
18.44cm
[7.26in]
2.69cm
[1.060]
2.79cm
[1.10in]
35.38cm
[13.93in]
0.97cm
[0.38in]
A
A
Tamper mounting location.
Note:
When power adapter model HS65WPSNA is not mounted inside
the enclosure model HSC3010C or HSC3020C, it must be attached to the
mounting surface using appropriate screws inserted through the mounting
tabs on the module.
- 3 -