Tyco iSTAR eX, Руководство по установке и настройке

Страница: 91 / 232

Mounting the Enclosure
iSTAR eX Installation and Configuration Guide 4–5
To mount the iSTAR eX controller (NPS model)
The power supply and battery will not be present on the NPS model.
1. Verify that the upper mounting screws (or equivalent) are in place on the
mounting site.
2. Carefully unpack the components. Observe static electricity precautions.
3. Open the enclosure door.
4. Carefully lift the door off the hinges and place it on a padded surface.
5. Align the mounting keyhole slots at the upper back of the enclosure with
the two upper mounting screws and lower the enclosure into position.
6. Install the two bottom mounting screws.
7. Remove the appropriate knockouts for wiring the inputs and outputs.
8. Remove the appropriate knockouts for the external Power Supply power,
AC Fail, and Low Battery.
9. Attach conduit couplings to the knockout openings as needed to comply
with code.
10. Connect the external Power Supply power, AC Fail, and Low Battery
connections from the external Power Supply to the iSTAR eX PMB.