kANGAROO
™ 924
3
Enteral Feeding Pump
Section II Operating Procedures
NOTE: To disconnect AC power it is necessary to unplug
power cord from the AC wall outlet.
AC Light
On whenever pump is plugged in.
Vol CLR Light
On when volume delivered has been cleared.
ON
Powers the pump (See Figure 3 for location).
OFF
Shuts pump off. NOTE: To disconnect AC power it is
necessary to unplug power cord from the AC wall outlet
(See Figure 3 for location)
Increases rate or VTBD desired.
Decreases rate or VTBD desired.
NOTE: NUMBERS DISPLAYED WILL CHANGE MORE RAPIDLY IF
EITHER ARROW BUTTON IS HELD IN.
Adjustment Knob
Increases or decreases rate or VTBD desired.
VOL
Displays volume delivered for 5 seconds when pressed.
When the pump has been off for 24 hours (16 hours battery),
the volume delivered is automatically reset to zero.
VOL CLR
Clears volume delivered when pressed after VOL has been pressed. The VOL CLR light will go on when volume delivered has been
reset to zero. Volume delivered cannot be cleared until the preset VTBD has been delivered or cleared.
VTBD (Volume To Be Delivered)
When pressed, allows user to preset a volume to be delivered by pressing or or rotating adjustment knob. Holding for 5
seconds will clear VTBD setting and volume. VOL CLR light flashes 3 times to signal that VTBD has been cleared.
START/HOLD
Starts pump rotor to deliver feeding formula to patient and alternately puts unit on HOLD. HOLD is used to stop fluid flow to:(1)
correct alarm condition-alarm is silenced (2) change the flow rate(3) change pump set. When on HOLD, the display flashes on and off
and the total delivery is retained.
NOTE: IF THE PUMP HAS BEEN PLACED ON HOLD AND NOT RESTARTED WITHIN 5 MINUTES, AN ALARM WILL SOUND.
Normal Operation
Insert power cord into AC wall outlet.
Figure 3
Status: Review Routing On: CR10000186 Doc#: AW10001678
11/10/2006 Artwork#s: WN 182493-01 Job#: 14761
