TYAN TITAN TURBO ATX-2, Руководство пользователя

Страница: 24 / 71

24
and so you cannot use a BUS master on slot 1 and slot 5 at the same
time.
After installing the peripheral controllers, you should check the CPU
and all your devices again before preparing to power on the system.
Connecting the Power Supply
The female power supply connector on the mainboard fits with the
male power supply connector from a 3.3V, 5V, or 12V power supply.
Beware: incorrect installation of the power supply can result in serious
damage to the system board and connected peripherals. Before con-
necting the leads from the power supply, you should first make sure
that the power supply is unplugged.
Most male power supply connectors will have twenty wires, seven of
which are black. The black wires will be in the middle of the connector.
The easiest way to orient the connectors properly is to line up the
plastic clip on the male connector with the tab on the female connector.
The plastic clip should be facing the middle of the motherboard.
Align the plastic guide pins on the male connector with their recep-
tacles on the mainboard. You may need to hold the lead at an angle in
order to properly line it up with the onboard connector. Once you have
the guide pins aligned, press the lead into the connector so that the
plastic clip on the lead snaps into place and secures the lead to the
connector. Please see the figure below.
Chapter 3
Onboard connector
Power supply connector (lead)
tab
clip
!