TYAN THUNDER I7522, Руководство пользователя

Страница: 54 / 61

Thunder i7520 / Thunder i75 20 R Appendix II: Post Error C o d e for B I O S
http://www. tyan.com
51
Appendix II: Post Error Code for BIOS
Code Beeps / Description Code Beeps / Description
02h Verify Real Mode 3Ah Autosize cache
03h Disable Non- Maskable Interrupt (NMI) 3Ch Advanced configuration of chipset registers
04h Get CPU type 3Dh Load alternate registers with CMOS values
06h Initialize system hardware 42 h Initialize interrupt vectors
08h Initialize chipset with initial POST
values
45h POST device initialization
09h Set IN POST flag 46h 2-1- 2- 3. Check ROM copyright notice
0Ah Initialize CPU registers 48h Check video configuration against CMOS
0Bh Enable CPU cache 49h Initialize PCI bus and devices
0Ch Initialize caches to initial POST values 4Ah Initialize all video adapters in system
0Eh Initialize I/O component 4Bh QuietBoot start (optional)
0Fh Initialize the local bus IDE 4Ch Shadow video BIOS ROM
10h Initialize Power Management 4Eh Display BIOS copyright notice
11h Load alternate registers with initial
POST values
50h Display CPU type and speed
12h Restore CPU control word during
warm boot
51h Initialize EISA board
13h Initialize PCI Bus Mastering devices 52h Test keyboard
14h Initialize keyboard controller 54h Set key click if enabled
16h 1-2- 2- 3. BIOS ROM checksum 58h 2-2- 3- 1. Test for unexpected interrupts
17h Initialize cache before memory
autosize 59h Initialize POST display service
18h 8254 timer initialization 5Ah Display prompt "Press F2 to enter SETUP"
1Ah 8237 DMA controller initialization 5Bh Disable CPU cache
1Ch Reset Programmable Interrupt
Controller 5Ch Test RAM between 512 and 640 KB
20h 1-3- 1- 1. Test DRAM refresh 60h Test extended memory
22h 1-3- 1- 3. Test 8742 KB D Controller 62h Test extended memory addres s lines
24h Set ES segment register to 4 GB 64h Jump to UserPatch1
26h Enable A20 line 66h Configure advanced cache registers
28h Autosize DRAM 67h Initialize Multi Processor APIC
29h Initialize POST Memory Manager 68h Enable external and CPU caches
2Ah Clear 512 KB base RAM 69h Setup System Management Mode (SMM)
area
2Ch 1-3- 4- 1. RAM failure on address 6Ah Display external L2 cache size
2Eh 1-3- 4- 3. RAM failure on data bits of
low byte of memory bus
6Bh Load custom defaults (optional)
2Fh Enable cache before system BIOS
shadow 6Ch Display shadow- area message
30h 1-4- 1- 1. RAM failure on data bits of
high byte of memory bus 6Eh Display possible high address for UMB
recovery
32h Test CPU bus-clock frequency 70h Display error messages
33h Initialize Phoenix Dispatch Manager 72h Check for configuration errors
36h Warm start shut down 76h Check for keyboard errors
38h Shadow system BIOS ROM 7Ch Set up hardware interrupt vectors
7Eh Initialize coprocessor if present BAh Initialize DMI parameters
80h Disable onboard Super I/O ports and
IRQs
BBh Initialize PnP Option ROMs