Tweco ArcMaster 201 TS, Руководство по обслуживанию

Страница: 32 / 80

TWECO 201TS OPERATION
Operation 4-6 Manual 0-5150
HF TIG (GTAW) Sequence of Operation
CAUTION
Before any welding is to begin, be sure to wear all appropriate and recommended safety equipment.
1. Switch the ON/OFF Switch (located on the rear panel) to OFF.
2. Connect the ground (work) clamp cable to positive output terminal. It is essential that the male plug is
inserted and turned fully clockwise until connector locks in place to achieve reliable electrical connection.
3. Connect the TIG torch as follows:
a) Place the power cable into the negative output terminal. It is essential that the male plug is inserted and
turned fully clockwise until connector locks in place to achieve reliable electrical connection;
b) Place the 8 pin plug into the 8 pin socket. To make connections, align keyway, insert plug, and rotate
threaded collar fully clockwise.
c) Place the TIG torch gas hose to the gas outlet and tighten with a wrench. Caution: DO NOT over tighten.
4. Using a secured Argon cylinder, slowly crack open then close the cylinder valve while standing off to the side
of the valve. This will remove any debris that may be around the valve & regulator seat area.
5. Install the regulator (for details of VICTOR regulator, please refer to 3.09 ) and tighten with a wrench.
6. Connect one end of the supplied gas hose to the outlet of the Argon regulator and tighten with a wrench. Cau-
tion: DO NOT over tighten.
7. Connect the other end of the supplied gas hose to the gas inlet fitting on the rear panel of the welder and tighten
with a wrench. Caution: DO NOT over tighten.
8. Open the Argon Cylinder Valve to the fully open position.
9. Connect the ground (work) clamp to your work piece.
10. Set the DOWN SLOPE control knob to the desire weld current ramp down time. Refer to Section 4.01.
11. Set the weld current control knob to the desired amperage.
12. The tungsten must be ground to a blunt point in order to achieve optimum welding results. It is critical to grind
the tungsten electrode in the direction the grinding wheel is turning.
13. Install the tungsten with approximately 1/8” to ¼” sticking out from the gas cup, ensuring you have correct
sized collet.
14. Tighten the back cap then open the valve on the torch.
15. Plug the power cable into the appropriate outlet, and turn the switch to the “ON” position. The power L.E.D.
light should illuminate. Set the “Process Selection Switch” to HF TIG
16. You are now ready to begin HF TIG Welding.
4.05 Welding Current Control Explanation
32 Amp Outlet
The mains power 32 Amp circuit breaker or fuse should not trip at this Weld Current value when STICK welding.
The environmental conditions that may cause the mains power 32 Amp circuit breaker or fuse to trip are:
a) High ambient temperature
b) Worn parts in circuit breaker
c) Using an extension cable
d) Low line mains power voltage