Tweco ArcMaster 201 TS, Руководство по обслуживанию

Страница: 27 / 80

OPERATION TWECO 201TS
Manual 0-5150 4-1 Operation
SECTION 4:
OPERATION
Conventional operating procedures apply when using the Welding Power Source, i.e. connect work lead directly
to work piece and electrode lead is used to hold the electrode. The welding current range values should be used
as a guide only. Current delivered to the arc is dependent on the welding arc voltage, and as welding arc voltage
varies between different classes of electrode, welding current at any one setting would vary according to the type
of electrode in use. The operator should use the welding current range values as a guide then fine tune the weld-
ing current to suit the specific application. Refer to the electrode manufacture's literature for further information.
4.01 Front Panel
Art # A-10146_AB
(A) Power On Indicator
(B) Fault Indicator
(E) Welding Current
Control
(G) Gas Outlet
Negative Output Terminal
Positive Output Terminal
(I) 8 Pin Control Socket
(F) Arc Force/Down
Slope Control
(D) Process Selection Switch
(C) Trigger Mode Selection Switch
32A OUTLET STICK
TIG
230V
110V
TIG/STICK
32A OUTLET
16A OUTLET
Figure 4-1: Tweco 201TS Controls
Front Panel
The welding power source is protected by a self re-setting thermostat. The indicator will illuminate if the duty
cycle of the power source has been exceeded. If the FAULT light illuminates wait for the FAULT light to extinguish
before resuming welding.
A. POWER Indicator
The POWER Indicator illuminates when the ON/OFF switch is in the ON position and the correct mains voltage is
present.