C2-3300 S
ERIES
O
PERATION
M
ANUAL
49
This first adjustment controls the type of transition desired: ‘Cut’, ‘Fade’, ‘Wipe’ or
‘Push’.
If you select ‘Cut’ or ‘Fade’, the only remaining menu items will be ‘Switching Fade
Time’ and ‘Exit’. Selecting ‘Wipe’ or ‘Push’ exposes additional parameters.
This parameter controls how long a transition from one input to another takes. The
value can be 0 (a cut) or several minutes - adjustable in 1/10
th
second increments.
If you selected ‘Wipe’ or ‘Push’ for the transition type, then you will be able to
specify the ‘movement direction’ of the transition that you want. Both ‘Wipe’ and
‘Push’ support: Left to Right, Right to Left, Up/Down (Top to Bottom), Down/Up
(Bottom to Top). ‘Wipe’ also supports: Diagonal and Diamond effect.
Wipe Size sets the ‘granularity’ of the ‘Wipe’ effect and so is only shown when
‘Wipe’ is the transition type. The smaller the number, the more elements there are
to the wipe. To clarify by example, if you select the Diamond wipe effect and set a
small number into the Wipe Size parameter, you will have a large number of
Diamonds present in the transition. On the other hand, a large number loaded into
the parameter will result in only one or two diamonds being present during the
transition.
9.8
Items Associated with the Adjust buttons group
This menu group allows re-programming of buttons on an attached CC-300
CORIOconsole, and also on some units with programmable front panel buttons
where the labels can be removed and customized.
For certain units without labeled buttons, this menu can be used when ‘Advanced
menus=On’ in the System menu – this is to allow re-assignment of buttons when
necessary. If required, a firmware update or system restore can be performed to
put all buttons back to their defaults.
Adjust transitions
Transition [Fade]
Adjust transitions
Switching fade time [ .5]
Adjust transitions
Wipe type [Left -> Right]
Adjust transitions
Wipe size [100]
