C2-3300 S
ERIES
O
PERATION
M
ANUAL
19
We’ll be using a Personal Computer for a signal source. Make certain that the
monitor resolution can display 1024 x 768 @ 60Hz as this is the default output
resolution for the C2-3300 series.
Disconnect the cable going from a Personal Computer’s Monitor to the Personal
Computer. Connect the output from the PC video card (the PC connector formerly
used by the monitor cable) to the input labeled “VIDEO INPUT 1” on the rear panel
of the Processor.
Next, take the cable from the PC monitor and connect it to the C2-3300 series’ DVI-
D / or VIDEO Program Output depending on the type of connection the monitor has.
Then connect the AC Power Cable to a working AC outlet, turn on the PC, monitor
and then the C2-3300 series.
Provided you have not changed anything from the Factory Defaults, the monitor will
display output 1024x768@60Hz and the image from the PC on input 1. If this is the
result, the C2-3300 series is passing and processing signals.
5.5
Initial Audio Operation Check
Following on from the video operation initial test, if the unit has the audio option,
connect an audio source to audio Input 1, and an audio amplifier and speakers to
the audio program out.
Again, provided you have not changed anything from the Factory Defaults, the
audio signal from input 1 should be audible on the program audio output. If this is
the result, the C2-3300 series is passing and processing signals.
The audio connections are balanced and care should be taken when wiring to
unbalanced (single ended audio sources and drivers).
