Tuxedo PL6K, Инструкция по установке и эксплуатации

Страница: 22 / 36

22
Lower the lift onto the nearest safety lock.
ALWAYS INSURE SAFETY LOCKS ARE ENGAGED
before entering work area.
 Check to make sure safeties are engaged on the
SAME
safety lock position
BEFORE ENTERING
work area.
To Lower Lift;
 Clear area of personnel and tools above and below
before lowering lift.
 Raise the lift at least two inches to provide
adequate clearance for the safety to operate.
 Press and
Hold
the Air Safety Release Button.
 Visually confirm that the safety bar has been raised
up off the safety locks. ( See Fig. 11.2 )
When lowering the lift PAY CAREFUL ATTENTION that
all personnel and objects are kept clear. ALWAYS keep
a visual line of site on the lift AT ALL TIMES. ALWAYS
make sure that all LOCKS are disengaged. If one of the
locks inadvertently locks on descent, the lift and/or vehi-
cle may disrupt causing personal injury or death.
 Push the LOWERING handle until the lift starts to
descend. Stay clear of lift area. Ensure that both
safeties are not engaged.
WARNING!
YOU MUST RELEASE THE AIR SAFETY BUTTON
WHEN LIFT IS 10 INCHES OFF THE GROUND.
FAILURE TO DO SO MAY RESULT IN DAMAGE TO
THE LIFT’S SAFETY COMPONENTS.
 Continue pressing the Lower Handle to Fully
lower the lift. Remove all lifting adapters before
driving vehicle away.
WEEKLY MAINTENANCE
 Lubricate all rollers with general purpose oil or
WD-40.
 Check all cable connections, bolts and pins to
insure proper mounting.
 Lubricate safety lock pivot points with general
purpose oil or WD-40.
MONTHLY MAINTENANCE

Check safety locks to insure they are in good
operating condition.
 Make a visual inspection of ALL MOVING PARTS
and check for excessive signs of wear
 Replace ALL FAULTY PARTS before lift is put
back into operation.

NEVER EXCEED THE RATED CAPACITY
of lift.

DO NOT USE LIFT
if any component is found to
be defective or worn.

NEVER OPERATE LIFT
with any person or
equipment below.

ALWAYS STAND CLEAR
of lift when lowering or
raising.

ALWAYS INSURE SAFETY LOCKS ARE
ENGAGED
before entering work area.

NEVER LEAVE LIFT IN ELEVATED CONDITION
unless all safety locks are engaged.